Suitable for use with small GEL/Sealed Lead Acid Batteries

24V 8A

24V 12A

12V 10A

• This range of intelligent microprocessor controlled switch mode battery charger is ideal for use with electric wheelchairs, scooters and all other light traction applications. The charger can be supplied with charging regime designed for a specific battery type, eg gel, agm or flooded
• Fully in accordance with EN 60335 part 2.259 : 1997, EN 12184 : 1999, EN 61000-3-2 : 1995, EN 55014-1 : 2000, EN 55014-2 : 1997, EN 60601-1 : 1990
• Complies with the EMC Directive
• CE Marked
• Class II appliance and IP31 rated

Standard Features include

• Full Current limit– the charger will not give more than its rated output
• Slow Start—there is a short delay after the battery is connected before charging commences, this is to ensure that a connection has been made.
• Reverse Polarity Protection– the charger is protected against incorrect battery connection.
• Low Voltage pick-up– the charger will recharge deeply discharged batteries.
• Self Discharge Protection—the battery will not self discharge through the charger if the charger is disconnected from the mains
• Overall Timer—Overall timer is included in the design  and will only operate if the battery fails to reach the first constant voltage level.
• Over voltage Protection—in the unlikely event of the charger developing a fault which causes the output voltage to rise more than a pre-determined level, the charger will shut down

Battery Maintenance—the battery may be safely left on charge in order to maintain the battery in a fully charged condition.