Suitable for use with small GEL/Sealed Lead Acid Batteries

24V 4A

24V 5A

230V 50Hz and 120V 60Hz Versions

This range of intelligent microprocessor controlled automatic battery chargers has been carefully designed for use with small GEL/sealed lead acid batteries.

The output characteristics is controlled to ensure compliance with each particular battery manufacturers recharge recommendations.

• Fully in accordance with European Standard EN 60335 Part 2.29 1991 and en 12184 1999
• Complies with the EMC Directive
• Impact resistant plastic case
• CE Marked
• Class II appliance and IP31 rated

Standard Features include

• Full Current limit– the charger will not give more than its rated output
• Slow Start—there is a short delay after the battery is connected before charging commences, this is to ensure that a connection has been made.
• Reverse Polarity Protection– the charger is protected against incorrect battery connection.
• Low Voltage pick-up– the charger will recharge deeply discharged batteries.
• Self Discharge Protection—the battery will not self discharge through the charger if it is connected with the mains disconnected.
• Overall Timer—Overall timer is included in the design  and will only operate if the battery fails to reach the first constant voltage level.
• Over voltage Protection—in the unlikely event of the charger developing a fault which causes the output voltage to rise more than 32 volts, the charger will shut down

Battery Maintenance—the battery may be safely left on charge in order to maintain the battery in a fully charged condition.